Option board
For a list of available option boards, see
An option board can be installed near the back of the system board that provides an additional connector on
the rear I/O panel.
NOTE:
The image in this section shows a serial port expansion board.
To remove the option board:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the two Phillips screws (1) that secure the board to the system board.
4.
Lift to disengage the board from the system board connector, and then remove the option board from
the computer (2).
To install the option board, reverse the removal procedures.
Boards, cards, and ports on page
(Preparation for disassembly on page
(Access panel on page
20).
8.
19).
Option board
67