Update Of Nckoem_Cc_0013_01.02.00 - Siemens sinumerik 840D sl Function Manual

Examples

4.2 Update of NCKOEM_CC_0013_01.02.00

A detailed description is contained in:
References:
/IAD/ Commissioning Manual SINUMERIK 840D/SIMODRIVE 611D
Insert the PC card
• Switch off control system
• Insert the PC card with the new firmware (technology card) in the PCMCIA slot of the
• Then proceed as follows:
Note
If number "6" does not appear, then one of the following errors might have occurred:
• Incorrect PC card (e.g. card for NCU2 in NCU3 hardware)
• Card hardware defective.
Copy back SRAM contents
To copy the saved data back into the control system, proceed as described in the section
entitled "Series start-up". Please read all information provided by the manufacturer about
new software versions.
• Enter the machine manufacturer password.
• Select "Data in" and "Archive...".
• Load the archive with the backed up compensation data (if applicable).
4.2 Update of NCKOEM_CC_0013_01.02.00
• Extended functionality CC_COPONM and collision protection
• Relocated machine data numbers, alarm numbers, VDI bytes and bits and new compile
18
NCU.
– Turn switch S3 on the front panel of the NCU to 1.
– Switch the control system back on again.
– During run-up, the firmware is copied from the PC card to the NCU memory.
– Wait until number "6" appears on the NCU digital display(after approximately 60 s).
– Turn switch S3 back to zero.
cycle no. (function can also be supplied on a technology card).
Special functions: MCS Coupling (TE6)
Function Manual, 11/2006, 6FC5397-2BP10-2BA0