EN 40
12.
12.3.
HDD (Hard Disk Drive)
12.3.1.
HDD Subassembly Removal
1.
Remove the top cover. See paragraph 12.1.1.
2.
Disconnect all cables (1) from the HDD. See Figure 12.3-1.
3.
Remove the 2 mounting screws (2) from the HDD subassembly. See Figure 12.3-2.
4.
Slide the HDD subassembly towards the left, until the locking tabs disengage.
5.
Remove the HDD subassembly from the chassis.
12.3.2.
HDD Subassembly Re-Assembly
To re-assemble the HDD subassembly, do all processes described in 12.3.1 paragraph in reverse order.
Note: The torque setting required for the HDD subassembly mounting screws (2) is 8kg-cm
12.3.3.
HDD Removal
1.
Remove the HDD subassembly. See paragraph 12.3.1.
2.
Remove the 4 mounting screws and bushes from the HDD.
3.
Slide the HDD out of the HDD cage.
12.3.4.
HDD Re-Assembly
To re-assemble the HDD, do all processes described in paragraph 12.3.4 in reverse order.
Note: The torque setting required for the HDD mounting screws is 4kg-cm
Note: There are no jumpers on the HDD that require configuration.
Note: When replacing a HDD a disc image must be installed on the new drive. See paragraph 13.
MCP9350i
Hardware Repair
1
Figure 12.3-1
2
2
Figure 12.3-2