Using Bgp To Advertise Vpn Routes To The Pe - HP 10500 Series Configuration Manual

The following output shows that PE 1 has learned the private route of VPN 2 through OSPF.
[PE1] display ip routing-table vpn-instance vpn2
Destinations : 13
Destination/Mask
0.0.0.0/32
40.1.1.0/24
40.1.1.0/32
40.1.1.2/32
40.1.1.255/32
127.0.0.0/8
127.0.0.0/32
127.0.0.1/32
127.255.255.255/32
192.168.10.0/24
224.0.0.0/4
224.0.0.0/24
255.255.255.255/32
Now, the routing information of the two VPNs has been redistributed into the VPN routing tables
on PE 1.

Using BGP to advertise VPN routes to the PE

Network requirements
As shown in
of each VPN can communicate with each other over the MPLS backbone.
Run OSPF in both VPNs 1 and 2, and run EBGP between the MCE and PE 1.
Proto
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
Direct 0
OSPF
Direct 0
Direct 0
Direct 0
Figure 5, configure the MCE to advertise the routes of VPNs 1 and 2 to PE 1, so that the sites
Routes : 13
Pre Cost
0
0
0
0
0
0
0
0
0
150 1
0
0
0
23
NextHop Interface
127.0.0.1 InLoop0
40.1.1.2 Vlan40
40.1.1.2 Vlan40
127.0.0.1 InLoop0
40.1.1.2 Vlan40
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
127.0.0.1 InLoop0
40.1.1.1 Vlan40
0.0.0.0 NULL0
0.0.0.0 NULL0
127.0.0.1 InLoop0