Toshiba MJ-1027 Service Manual page 155

9) Insert the tool [10] into the staple slot of
the stitcher [9].
10) Shift down the stitcher, and turn the stitcher
gear so that the boss on the tool [11] and
the recess of the mount match. Then, tighten
the screws [12] on the mount to fix the two
in place.
6. Removing the Positioning Plate
Unit
1) Remove the saddle stitcher controller PCB
(see II-C-1).
2) Disconnect the two connectors [1], remove
the three harness stops [2], and remove the
harness leads [3] from the two edge saddles
[4].
3) Remove the two screws [5], slide the posi-
tioning plate unit [6] once towards the front
and remove from the rear side.
CHAPTER 4 MECHANICAL CONSTRUCTION
[10]
Figure 4-229
[11]
[12]
Figure 4-230
[2]
Figure 4-231
[9]
[3]
[6]
[1]
[5] [4]
4-25