When connecting with an HDMI cable to an amplifier,
use the
following settings on this unit if you cannot set the speaker delay
effect on the amplifier.
I Speaker
presence
(_)
and size
Press [A, Y, _1, I_] to select the speaker icon ((A_)and then
press [ENTER].
Press [A, Y] to select the setting and then press [ENTER].
Icon examples:
Surround speaker (LS)
Large
Small
No
oLarge:
Select when the speaker supports low-frequency
(under
100 Hz) reproduction.
oSmall:
Select when the speaker does net support low-frequency
reproduction.
If the subwoofer is set to "No", the front speakers will automatically
be set to "Large". (In this case, we recommend connecting a
speaker that can reproduce bass below 100 Hz.)
I Delay time (@)
(Effective when playing multi-channel
audio)
If either distance _c_or _E_ is less than (.D_, find the difference in the
relevant table and change to the recommended
setting.
Press [A, V, 41, I_] to select the speaker icon (_) and then
press [ENTER].
Press [A, Y] to select the setting and then press [ENTER].
(_ Center speaker
Difference
Approx. 34 cm (1V_0feet)
Approx. 68 cm (2V5 feet)
Approx. 102 cm (33/_ofeet)
Approx. 136 cm (42/sfeet)
Approx. 170 cm (51/2feet)
(E_Surround speakers
Difference
Approx. 170 cm (51/2feet)
Approx. 340 cm (11 feet)
Approx. 510 cm (161/2 feet)
Setting
1.0 ms
2.0 ms
3.0 ms
4.0 ms
5.0 ms
Setting
5.0 ms
10.0 ms
15.0 ms
RQT8346