Dust Cover Disassembly - Motorola CP140 Basic Service Manual

Non-Keypad Model Disassembly and Re-assembly: Disassembling and Re-assembling the Radio — General
6. Pull the chassis assembly out of the front cover only until the volume and channel selectors shaft
just clear the top of the case.
Rotate the chassis counterclockwise out of the housing and position next to the housing. Take care
not to damage the speaker and microphone wires that are still connected to the chassis
Microphone
Connector
7. Unplug the speaker wire assembly from the 2-pin connector on the chassis.
8. Unplug the microphone wire assembly from the socket on the chassis.
9. Move the chassis away from the housing and place on a clean work surface.

8.4.1.2 Dust Cover Disassembly

1. Gently pry the top of the dust cover away from the body of the radio. (See
2. Rotate the dust cover 90° in a counterclockwise direction to allow the key to be removed.
3. Separate the dust cover away from the body of the radio. The dust cover key is fragile; apply only
light pressure to the key while removing the dust cover.
a. Pry dust cover from body.
(Figure 8-4).
Figure 8-4. Microphone and Speaker Connections
b. Rotate dust cover 90
allow key to be removed.
Figure 8-5. Dust Cover Disassembly
Speaker Connector
Shroud
°
c. Separate dust
to
cover from body.
8-5
(Figure 8-4).
Figure 8-5).
key