Table of Contents
Advertisement
Exchanging Button
Labels
A button top puller is supplied with the center control
panel.
After changing a pattern assigned to a numeric button, you
can use the following procedure to exchange the button
label.
1
Write the new pattern on one of the supplied exchange
labels.
2
Grip the holes on the button sides with the supplied
button top puller and remove the button.
3
Grip the slots on the sides of the white button cap with
the button top puller, so that the cap flexes slightly,
and remove the cap.
4
Remove the old label and insert the new label.
5
Replace the button cap.
6
Replace the button in its original location.
2
Adjusting Fader Torque
You can adjust faders without removing them from the
center control panel or operation modules (Single fader
only).
Proceed as follows to adjust faders.
1
2
Rotate clockwise:
Fader lever operation becomes firmer.
Rotate counterclockwise:
Fader lever operation becomes freer.
3
Note
For a split fader, you cannot make adjustment from the
control panel surface. To make adjustment, it is necessary
to use the two holes provided in the back side of the
module.
If you want split fader torque to be adjusted, consult your
Sony service representative.
Single fader modules
CCP-6224 2M/E Control Panel
CCP-6324 3M/E Control Panel
MKS-8020A Standard Transition Module
MKS-8030A Key Frame Module
MKS-8032A DSK Fader Module
MKS-8027A Compact Transition Right Module
MKS-8028A Compact Transition Left Module
Split fader modules
MKS-8021A Simple Transition Right Module
MKS-8022A Simple Transition Left Module
MKS-8021ASC Simple Transition Compact Right
Module
MKS-8022ASC Simple Transition Compact Left Module
Fader lever
Pull the fader lever to an upright position between the
two holes on the fader cover.
Insert a hexagonal screwdriver or a hexagonal wrench
(4 mm sides) into one or both of the holes and rotate
to adjust the torque.
Exchanging Button Labels / Adjusting Fader Torque
Hexagonal wrench
19
Hide quick links:
Advertisement
Table of Contents
