Setup - Canon CS100 Instruction Manual

Setup

Installing Batteries into the Remote Control
The remote control uses two AAA/R03 batteries (provided).
When replacing batteries, use two new batteries of the same brand. In the case of
rechargeable batteries, use fully-charged batteries of the same brand.
Connecting Connect Station to a TV Set
Connect Station must be connected to a TV set so that you can operate it while
looking at the TV screen. When connecting Connect Station to a TV set, prepare an
HDMI cable (commercially available) and connect according to the procedure below.
14
(1) Open the battery compartment
cover by putting a coin or other
similar object in the cover's
groove and turning it.
(2) Insert batteries in the battery
compartment, making sure that
their plus and minus ends are
correct, then close the cover.
1
Connect the HDMI cable to
Connect Station.
Plug the cable connector to the
HDMI terminal of Connect
Station.