Inserting And Removing An Sd Card - Canon EOS C700 Instruction Manual

Preparing Recording Media
IMPORTANT
• Observe the following precautions while a CFast card access indicator is illuminated in red. Failure to do so
may result in permanent data loss.
50 - Do not remove the power source or turn off the camera.
- Do not open the cover of the CFast card slot being accessed.

Inserting and Removing an SD Card

1 Wait until the SD card access indicator is off or is illuminated in
green.
2 Slide the SD card slot cover switch in the direction of the arrow.
• The SD card slot cover will open to the left.
3 Insert the SD card straight, with the label toward the back of
the camera, all the way into the SD card slot until it clicks.
• To remove the SD card, wait until the access indicator is off and
then push the SD card once to release it. When the SD card
springs out, pull it all the way out.
4 Close the SD card slot cover.
• Do not force the cover closed if the SD card is not correctly inserted.
SD card access indicator
SD card access indicator
Red
Green
Off
If you set
illuminate.
IMPORTANT
• Observe the following precautions while the SD card access indicator is illuminated in red. Failure to do so may
result in permanent data loss.
- Do not remove the power source or turn off the camera.
- Do not remove the SD card.
• SD cards have front and back sides that are not interchangeable. Inserting an SD card facing the wrong
direction can cause a malfunction of the camera. Be sure to insert the SD card as described in step 3.
NOTES
• SD cards have a physical switch to prevent writing on the card so as to avoid the accidental erasure of the
card's content. To write-protect the SD card, set the switch to the LOCK position.
SD card status
Accessing the SD card.
Simultaneous sub recording of XF-AVC Proxy clips is
activated and the SD card is ready for recording, or
playback of XF-AVC Proxy clips and photos is possible.
An SD card is not inserted, the SD card is not being
accessed, or the SD card is write-protected with the LOCK
switch.
[System Setup] > [LED] > [Media Access] to [Off], the card access indicators will not
SD card access indicator