Configuring A Ds-Lite Tunnel - HP FlexNetwork MSR2003 Configuration Manual

56 bytes from 30.1.3.1: icmp_seq=1 ttl=255 time=1.000 ms
56 bytes from 30.1.3.1: icmp_seq=2 ttl=255 time=0.000 ms
56 bytes from 30.1.3.1: icmp_seq=3 ttl=255 time=1.000 ms
56 bytes from 30.1.3.1: icmp_seq=4 ttl=255 time=1.000 ms
--- Ping statistics for 30.1.3.1 ---
5 packet(s) transmitted, 5 packet(s) received, 0.0% packet loss
round-trip min/avg/max/std-dev = 0.000/1.200/3.000/0.980 ms

Configuring a DS-Lite tunnel

A B4 tunnel interface can establish a tunnel with only one AFTR tunnel interface, but an AFTR tunnel
interface can establish tunnels with multiple B4 tunnel interfaces.
Follow these guidelines when you configure the B4 router of a DS-Lite tunnel:
•
Do not specify the same source addresses for local tunnel interfaces in the same tunnel mode.
•
The destination address specified for the tunnel interface on the B4 router must be the source
address specified for the tunnel interface on the AFTR.
•
To ensure correct packet forwarding, identify whether the destination IPv4 network and the IPv4
address of the local tunnel interface are on the same subnet. If they are not, configure a route
reaching the destination IPv4 network through the tunnel interface. You can configure the route
by using one of the following methods:
Configure a static route, and specify the local tunnel interface as the egress interface or
specify the IPv6 address of the peer tunnel interface as the next hop.
Enable a dynamic routing protocol on both tunnel interfaces to achieve the same purpose.
For more information about route configuration, see Layer 3—IP Routing Configuration Guide.
Follow these guidelines when you configure the AFTR of a DS-Lite tunnel:
•
Do not specify the same source addresses for local tunnel interfaces in the same tunnel mode.
•
Enable NAT on the interface that connects to the public IPv4 interface.
•
The tunnel destination cannot be configured on the AFTR. The AFTR uses the address of the
B4 router as the IPv6 address of the tunnel destination.
•
It is not necessary to configure a route to the destination IPv4 address for forwarding packets
through the tunnel interface.
This section describes only the AFTR configuration. For information about B4 router configuration,
see "Configuring an IPv4 over IPv6 manual
To configure the AFTR of a DS-Lite tunnel:
Step
1. Enter system view.
2. Enter the view of the
tunnel interface on the
AFTR.
3. Specify an IPv4 address
for the tunnel interface.
tunnel."
Command
system-view
interface tunnel
number [ mode
ds-lite-aftr ]
ip address ip-address
{ mask | mask-length }
[ sub ]
311
Remarks
N/A
N/A
By default, no IPv4 address is specified for the
tunnel interface.