Chapter 2. Preparing to Install the 4.7GB SCSI-2 DVD-RAM Drive
This chapter covers all the things you need to do before you install your 4.7GB SCSI-2
DVD-RAM Drive. Preparing to install the drive involves the following tasks:
v Verifying your hardware requirements
v Verifying your software requirements
v Making sure your package is complete
v Gathering tools and documentation
v Planning your SCSI device layout
v Determining your SCSI device address
v Setting the SCSI address
Verifying Your Hardware Requirements
The 4.7GB SCSI-2 DVD-RAM Drive requires the following hardware:
v An available bay large enough to hold a 5-1/4 inch half-high device
v A SCSI-2 adapter, which is either built into or on a separate adapter card inside your
system unit
v A SCSI interface cable
v A 50- to 68-pin interposer
Verifying Your Software Requirements
The 4.7GB SCSI-2 DVD-RAM Drive is supported on AIX 4.3.3 operating system or later.
Ensure that your operating system supports this DVD-RAM drive before you install it.
Contact your support representative for assistance.
Checking Your Package
Check that your package contains the following items:
v The 4.7GB SCSI-2 DVD-RAM Drive
v Mounting screws
v A CD-ROM test disc
v A DVD-RAM test disc
v A 50- to 68-pin interposer
v A registration card
v 7 jumpers (included on the jumper block)
v Cleaning Kit
Contact the place of purchase if an item is missing or damaged.
Important: Be sure to retain your proof of purchase because it might be required to
receive warranty service.
3