D-Link DIR-822 User Manual page 114

DIR-822 AC1200 Wi-Fi Router
User Manual
Figure 97. The page for creating a new PPTP + Static IP connection. The Authorization via 802.1x
Parameter
Authorization in the
ISP's network via
802.1x protocol
Authentication
method
Username
Password
Isolate connection
Enable RIP
Enable IGMP Multicast
NAT
Firewall
Ping
protocol section.
Authorization via 802.1x protocol
Select the checkbox to allow authorization in the ISP's network via
the 802.1x protocol.
Select a needed authentication method from the drop-down list.
Enter the username provided by your ISP.
Enter the password provided by your ISP.
When the checkbox is selected, the router uses an alternate routing
table for this connection. Select the checkbox only when your ISP
requires this.
Select the checkbox to allow using RIP for this connection.
Select the checkbox to allow multicast traffic from the external
network (e.g. video streaming) to be received.
Select the checkbox if you want one WAN IP address to be used for
all computers of your LAN.
Select the checkbox to enable protection against ARP and DDoS
attacks.
Select the checkbox to allow the router to answer ping requests
from the external network through this connection. For security
reasons, it is recommended not to select this checkbox.
Page 114 of 212
Configuring via Web-based Interface
Description