Correcting Faults; Temperature Sensor - Miele G 7881 Installation And Operating Instructions Manual

Correcting faults

Temperature sensor

The washer-disinfector is equipped with
a (re-settable) temperature sensor that
switches off the heater when it
threatens to overheat. Overheating can
occur when, for example, large items
cover the heating elements or if the
filters in the wash cabinet are blocked.
If the display shows any of the following
fault messages: F01 - F03, F18, F19
(the water in the wash cabinet does not
get hot; the program sequence lasts
too long) take the following steps:
^ Remove the underlying cause.
^ Remove the service panel.
^ Press the re-set button for the ther-
mostat on the right side of the plinth.
If the thermostat is triggered again,
please contact Miele Customer Ser-
vice without delay.
63