Flash Memory Control Register 2 (Flmcr2) - Hitachi H8S/2646 Hardware Manual

Bit 0—Program (P): Selects program mode transition or clearing. Do not set the SWE, PSU,
ESU, EV, PV, or E bit at the same time.
Bit 0: P Description
0 Program mode cleared
1 Transition to program mode
[Setting condition]
When FWE = 1, SWE = 1, and PSU = 1
20.5.2

Flash Memory Control Register 2 (FLMCR2)

FLMCR2 is an 8-bit register used for flash memory operating mode control. FLMCR2 is
initialized to H'00 by a reset, and in hardware standby mode and software standby mode. When
on-chip flash memory is disabled, a read will return H'00.
Bit:
Initial value:
R/W:
Note: FLMCR2 is a read-only register, and should not be written to.
Bit 7—Flash Memory Error (FLER): Indicates that an error has occurred during an operation on
flash memory (programming or erasing). When FLER is set to 1, flash memory goes to the error-
protection state.
Bit 7: FLER Description
0 Flash memory is operating normally
Flash memory program/erase protection (error protection) is disabled
[Clearing condition]
Reset or hardware standby mode
1 An error has occurred during flash memory programming/erasing
Flash memory program/erase protection (error protection) is enabled
[Setting condition]
See section 20.8.3 Error Protection
Bits 6 to 0—Reserved: These bits always read 0.
7 6
FLER —
0 0
R R
5 4 3
— — —
0 0 0
R R R
(Initial value)
2 1 0
— — —
0 0 0
R R R
(Initial value)
669