Table of Contents
Advertisement
Specifications
General Specifications
Brush Filament Material
Brush Diameter
Oscillation Angle
Sweeping Width Angle
Castor Wheels
Ground Clearance
Brush Speed
Brush Ground Pressure
Adjustment
Hydraulic/Mechanical
Brush Drive
Brush Swing/Control
Electrical Connection
Weight
Note: Specifications and design subject to change without notice.
Optional Equipment
High carbon wire brush filament
Virgin polypropylene, high carbon wire or combination of both.
Uses 24 inch brush elements.
8 degrees.
Brush swings 25 degrees in both directions. 70.5 inches sweeping width @ center
position, 64 inches minimum sweeping width @ full swing left or right.
Two 8.0 inch x 3.5 inch pneumatic rubber tires
6 inch
220 rpm, no load for Groundsmaster 4000.
240 rpm, no load for Groundsmaster 4100
Adjustment is with .5 inch spacers and holes in castor fork.
6.10 cubic inch roller vane motor drives directly into 16 tooth sprocket. A 40 tooth
sprocket is mounted on brush shaft. One #60 chain connects motor and brush.
A 2 inch bore, 15 inch stroke, swing cylinder is connected in parallel with hydraulic
brush drive. The cylinder is controlled by 3–position, closed center, 4–way solenoid
directional valve. A 6 mm grade 8.8 shear bolt connects rod end of cylinder to
4–bar linkage.
Wire Harness Kit, Part No.110–3263 is required for traction unit model numbers
30410 and 30411 or Part No. 115–8492 for models numbers 30412 and 30412 .
Order the appropriate kit from your Local Toro Distributor.
642 lbs.
Part No. 95–5942
5
Advertisement
Table of Contents
