DHCP Setting (Option 13)
DHCP is a Dynamic Host Automatic Configuration Protocol that allows a
server to dynamically assign IP addresses to workstations.
1. Press OPTIONS, numeric key "1", "3", then ENTER.
DHCP SETTING
SUPPORTED
(If NON SUPPORTED was selected previously, the screen will show
"NON SUPPORTED.")
2. Press ENTER.
ENTER USER PASSWORD
3. Enter 4 digits of numeric password (see User Password Registration in
chapter 4).
ENTER USER PASSWORD
****
* Factory Default User Password - 9999
4. Press ENTER.
1: SUPPORT
5. Press 1, then ENTER for support of DHCP . (Or press 2, then ENTER to
deactivate support of DHCP .)
SUPPORTED
COMPLETED
6. Press OPTIONS to exit the option menu. The telephone will reboot
automatically.
When 1: SUPPORT is selected, but the set could not obtain IP address, the
following error message will be shown:
DHCP Outage
User can manually enter the IP Address by going back to Menu by pressing
OPTIONS while DHCP ERROR message is displayed.
(See IP Address Registration Option 14 in this chapter).
Press either asterisk (*) to go back to sub-menu or OPTIONS to exit the option
menu.
2: NO SUPPORT
(SELECT 1-2)
2
2-3