Lubrication; Greasing The Sprayer - Toro 41177 Multi-Pro 1250 Operator's Manual

Figure 34
1. Front jacking points
The jacking point at the rear of the sprayer is on
the rear frame support, between the angle welds
(Figure 35).
Figure 35
1. Rear jacking points

Lubrication

Greasing the Sprayer

Lubricate all bearings and bushings after every
100 hours or once a year, whichever occurs first.
Grease Type: No. 2 General Purpose Lithium
Base Grease
1. Wipe the grease fitting clean so that foreign
matter cannot be forced into the bearing or
bushing.
2. Pump grease into the bearing or bushing.
3. Wipe off excess grease.
The grease fittings positions are illustrated by
the following: Figure 36through Figure 42.
Figure 36
At the wheels, three on each side
1. Grease point
Figure 37
Steering rods
1. Grease point
42