Installation; Led Display Of Functions - Siemens Gigaset repeater Operating Instructions Manual

Installation

Installation

LED display of functions

18
Once you have registered your Gigaset Repeater you can
install it wherever you would like to extend the reception
range of your handsets. However, you must ensure that
there is a power point at the place of installation and that
the left LED remains on constantly after the device has
been switched on.
If the left LED flashes, the Gigaset Repeater is too far
away from the base station or reception is being hindered
by thick walls or metal objects for example (e.g. radiators).
When looking for a suitable installation site, a useful guide
is a handset which requires a good connection with the
base station at the Gigaset Repeater installation site.
To operate a handset for the first time in the extended
Gigaset Repeater area, switch off the handset within the
new reception range of the Gigaset Repeater, but outside
the reception range of the base station and then switch it
back on again:
Base station
If you are using more than one Gigaset Repeater
in the area of your base station, you must keep
the Gigaset Repeaters at least 10m apart.
There are two green LEDs on the centre front of the hous-
ing. The left LED displays registration and operation func-
tion, the right LED displays the handset-traffic via this re-
peater:
Left LED states:
Dark
Flashing
Continuous lighting
Intermittent flashing
Right LED states:
Dark
Flashing once
Flashing twice
Gigaset Repeater
s
G iga se
t
R ep ea
ter
Extended reception area
power supply off
no link to basestation
normal link to basestation
ready to register
no traffic
one handset link via repeater
two handset link via repeater