Table of Contents
Advertisement
Installation of the Mediamaster
Connecting to the TV
• Connect the SCART cable between the main SCART socket on the TV and
the TV SCART socket on the Mediamaster.
• Connect the TV aerial to the TV.
Connecting a TV and VCR
Refer to your VCR's manual for full instructions.
• Connect one SCART cable from the main SCART socket on the TV to the TV
SCART socket on the Mediamaster.
• Connect another SCART cable from the VCR to the AUX SCART socket on the
Mediamaster.
• Connect the RF cable from the RF output on the VCR to the TV aerial input on
the TV.
• Connect the TV aerial to the RF input socket on the VCR.
Connecting an analogue satellite receiver and a VCR
• Connect a SCART cable from the main SCART socket on the TV to the TV SCART
socket on the Mediamaster.
• Connect a SCART cable from the VCR to the AUX SCART socket on the
Mediamaster.
• Connect an RF cable from the RF output on the VCR to the TV aerial input on
the TV.
• Connect an RF cable from the RF output on the analogue receiver to the RF in-
put socket on the VCR.
• Connect the TV aerial to the RF input socket on the analogue receiver.
In order to switch the signal from the dish between the analogue and digital re-
ceivers, you will need a Nokia smart switch (at A B in the diagram) or a Univer-
sal Twin LNB.
Nokia smart switch
• Connect a coaxial cable from output A on the smart switch (accessory) to the
LNB socket on the analogue receiver.
• Connect a coaxial cable from output B on the smart switch to the ANTENNA
socket on the Mediamaster.
The analogue receiver must be switched OFF (in standby mode) when you
want to watch digital satellite channels from the Mediamaster.
GB 12
1
SCART
VCR
RF
1
SCART
SCART
Mediamaster
With Nokia smart
switch
NOKIA Smart
priority switch
VCR
RF
SCART
1
Analogue receiver
Nokia smart switch
B
A
Advertisement
Table of Contents
