Canon VB-H43 Operation Manual page 153

(1) [Haze Compensation]
[Auto]
Automatically uses Compensation Removal.
[Manual]
Use buttons in (2) to manually set the compensation
strength.
[Disable]
Disables Haze Compensation.
(2) Haze Compensation Strength
When Haze Compensation is [Manual], set one of the
7 levels from [1] (Mild) to [7] (Strong).
Important
If you set [Smart Shade Control] to [Auto] or [Manual], [Haze
Compensation] is set to [Disable].
Note
• When [Auto] or [Manual] is selected for [Haze Compensation],
the video data size increases.
• When using [Haze Compensation], contrast may be strong if
the subject is not obscured by haze. If this happens, set [Haze
Compensation] to [Manual] and set a lower Haze
Compensation strength.
Setting the Focus
[Auto]
:Automatically focuses on the
subject.
[Manual] : You can adjust the focus manually
by pushing the
(near) buttons.
Clicking [One-shot AF] will use
autofocus to focus on a subject and
then stop in manual focus.
[Fixed at Infinity] : You can set the focus so that it is
fixed near infinity.
Important
• If it is set in the Admin Viewer, the same focus mode will
occur in the viewers of other users also.
• Depending on the lighting used, focus may not be
maintained when switching between [Day Mode] and [Night
Mode]. Focus when switching Day/Night Mode can be set in
the [Day/Night Mode Focus Settings] panel in the Admin
Viewer (p. 155).
• Setting the shutter speed at [1/1 sec] in manual exposure
(p. 153) will disable the [Auto] and [One-shot AF] focus
modes in Control for Admin. Switch the focus to [Manual] and
adjust it to your subject.
• Refer to the following for focus ranges.
• Changes to focus mode in the Admin Viewer will not be
reflected in the settings on the setting page.
• Note that if you set the focus manually it will remain fixed.
Setting the Exposure
(1) Exposure Mode
Select from [Auto], [Manual], [Auto (Flickerless)] or
[Auto (Shutter-priority AE)].
If [Auto] is selected for [Day/Night] under [Camera] in
the Setting page (p. 57), select [Auto], [Auto
(far) and
(Flickerless)] or [Auto (Shutter-priority AE)].
Performing Operations and Settings in the Admin Viewer
Notes on p. 58
Notes on p. 42
(6) (7)
[Auto]
The exposure is controlled automatically.
[Manual]
The exposure is set by adjusting the shutter speed,
aperture and gain values manually.
[Auto (Flickerless)]
In this mode, video flickering caused by fluorescent
lights, etc., can be reduced. The shutter speed is
automatically adjusted according to the brightness
of the environment in which the camera is used.
[Auto (Shutter-priority AE)]
In this mode, the desired shutter speed can be
specified.
6
(1)
(2)
(3)
(4)
(5)
153