Table of Contents
Advertisement
Navi Bars
Lock channels
To open this menu, you will be asked to enter your access code.
The access code is set to 1234 at the factory.
You can lock (and later unlock) channels on any of the lists in order
to prevent your children from watching them, etc. Three different
symbols can be shown beside the channel name.
= a channel that you have not previously visited.
= the channel is scrambled.
= the channel is locked by the user.
Select the channel that you want to lock or unlock and press info.
Repeat the procedure for each channel that you want to lock. When
you lock a channel on any list, the channel will automatically be
locked on all other lists.
• Press opt if you want to preview the channel.
A locked channel will be indicated by a padlock symbol.
• Press OK to confirm.
You must enter your access code before you can watch a locked
channel.
Control folder
—
You can add a new satellite to the system. You can also edit or
delete existing satellites.
To add a new satellite
• Select "Add Satellite".
• Enter the name of the new satellite. (For more information on
entering a name, see page 20.)
• Enter the orbital position (in degrees) using the number
buttons.
• Select an orientation, East or West.
• Press OK to save these settings.
Before you can watch channels from that new satellite, you must
also carry out the following steps:
For a fixed antenna
• Select "Antenna" in the Navi Bars.
• Adjust the antenna towards the new satellite. NOTE: With a
user-defined satellite, you do not see a TV picture on the screen.
When the signal strength is at its best:
• Press OK to confirm the new settings.
• Press back to return to the Navi Bars.
• Select "Channel" in the Navi Bars.
• Select "Manual" or "Advanced" search.
• Enter the settings for the transponder frequency, polarization,
etc. for the new satellite.
GB 22
Edit satellites
Advertisement
Table of Contents
