ELECTRICAL
CHECKING THE SPARK PLUG
NOTE:
Remove a mud and dust from the cylinder head
before removing the spark plug.
1. Inspect:
Electrode
●
Wear/Damage → Replace.
Dirt/Carbon deposit → Clean the spark plug
with a spark plug cleaner or wire brush.
Wear/Damage → Replace.
plug gap
●
Out of specification → Regap.
Spark plug gap
0.6∼0.7mm
CAUTION:
Do not run the kart with a plug gap larger
than the specified value.
NOTE:
When the engine runs for many hours at low
speeds, the spark plug insulator will become
sooty, even if the engine and carburetor are in
good operating condition.
TIGHTEN THE SPARK PLUG
CAUTION:
Do not tighten the spark plug with a plug wrench
from the start. It may damage the screw thread
in the cylinder head.
Finger-tighten
●
to specification
Spark plug
1.5∼2.5kg・m
NOTE:
Before installing the spark plug, clean the
●
gasket surface and plug surface.
Do not tighten the plug above the specified
●
torque.
3-10
INSP
ADJ
Standard spark plug
Manufacturer
B9EVX
NGK
the spark plug before torquing
.