Table of Contents
Advertisement
Panel saving
Choose to enable the panel saving functions to reduce the risk of the "image persistence". Press the
SET/PLUS button to open the submenu, and then press the UP/DOWN button to toggle between
COOLING FAN - Select On and the cooling fan is activated all the time. Select AUTO and the
cooling fan will turn on/off according to the temperature of display.
Note: The conditions of the cooling fan are low/mid/high speed at 50/58/63 °C respectively. The
display will automatically shut down if a preset critical temperature (82 °C) is reached.
Brightness - Select On and the brightness of the image will be reduced to an appropriate level,
and the Brightness setting in the Picture menu will become unavailable. Use the PLUS/MINUS
button to make selection.
Pixel Shift - Select the time interval for the monitor to slightly expand the image size and shift the
position of pixels in four directions (up, down, left, and right). Use the PLUS/MINUS button to make
selection (Off, AUTO, 10-900 seconds from current time).
IMPORTANT: It is not recommended to keep a single static image displayed on your unit for long periods
of time. This can cause image sticking, or ghost images, which will decrease the quality of your images.
In some instances, ghost image damage can be permanent. Ghost imaging is also not covered by
warranty, so in order to avoid such issues, we strongly recommend one of the following actions:
Change the picture periodically
Enable Pixel shift (See Pixel shift under Section 4.2.5.CONFIGURATION 1 MENU)
Use a screen saver with changing image
Serial control port
Choose to enable or disable the function of the control port.
Press the SET/PLUS button to open the submenu, and then press the UP/DOWN button to make
selection.
Configuration reset
Reset all settings in the Configuration 1 menu.
Press the SET/PLUS button to open the submenu, and then press the PLUS/MINUS button to make
selection. Select Reset and press the SET button to restore settings to factory preset values. Press
the EXIT button or select Cancel and press the SET button to cancel and then return to the previous
menu.
Factory reset
Reset all settings in the Picture, Screen, Audio, PIP, Configuration 1, Configuration 2, and
Advanced option menus. Press the SET/PLUS button to open the submenu, and then press the
PLUS/MINUS button to make selection. Select Reset and press the SET button to restore settings to
factory preset values. Press the EXIT button or select Cancel and press the SET button to cancel and
then return to the previous menu.
Philips BDL5545E
28
Hide quick links:
Advertisement
Table of Contents
