ICs inside the unit. 3. To protect the pickup unit from electrostatic discharge during servicing, take an appropriate treatment (shorting-solder) by referring to "the DISASSEMBLY". 4. After replacing the pickup unit, be sure to check the grating. DEH-30MP/XU/EW...
Page 3
To protect products from damages or failures during transit, the shipping mode should be set or the shipping screws should be installed before shipment. Please be sure to follow this method especially if it is specified in this manual. DEH-30MP/XU/EW...
• Screw adjacent to mark on the product are used for disassembly. • For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions,apply as you think it appropriate.) 2.1 PACKING DEH-30MP/XU/EW...
Page 7
16-6 Warranty Card CRY1157 Bush CNV3930 Case Assy CXB3520 Cord Assy CDE7059 Carton YHG5075 Contain Box YHL5075 Owner's Manual,Installation Manual Part No. Language YRD5060 English, Spanish YRD5061 German, French YRD5062 Italian, Dutch, Russian YRD5059 English, Spanish, German, French, Italian, Dutch, Russian DEH-30MP/XU/EW...
Note: When ordering service parts, be sure to refer to " EXPLODED VIEWS AND PARTS LIST" or "ELECTRICAL PARTS LIST". Large size SCH diagram CN901 FM : -20dBs AM : -20dBs Guide page Detailed page CD : 0.35dBs ANTENNA AUX : 2.21dBs SYSTEM MICROCOMPUTER CN1801 DEH-30MP/XU/EW...
Page 15
10k ohms The > mark found on some component parts indicates the importance of the safety factor of the part. *Capacitors Therefore, when replacing, be sure to use parts of Code Practical value identical designation. 0.01uF 101/10 100uF/10V DEH-30MP/XU/EW...
3.4 CD MECHANISM MODULE(GUIDE PAGE) PICKUP UNIT(P10.5)(SERVICE) SWITCHES: CD CORE UNIT(S10.5COMP1) S901:HOME SWITCH..ON-OFF S903:DSCSNS SWITCH..ON-OFF S904:12EJ SWITCH.....ON-OFF S905:8EJ SWITCH....ON-OFF The underlined indicates the switch position. CD DRIVER M1 CXC6742 SPINDLE MOTOR M2 CXC4026 LOADING/CARRIAGE MOTOR DEH-30MP/XU/EW...
Page 23
FOCUS SERVO LINE are expressed as : TRACKING SERVO LINE ← ← CARRIAGE SERVO LINE 0.022 R022 SPINDLE SERVO LINE CD CORE UNIT(S10.5COMP1) + 3.3 V REGULATOR CD3VON(MCKRQ) SRAMLEVEL2 ADENA SRAMLEVEL1 SRAMLEVEL0 (S904) CD CONTROLLER (S905) CN701 DEH-30MP/XU/EW...
Page 28
200 mV/div 500 mV/div ! TE 500 mV/div 8 TIN 500 mV/div CD-ROM play operation(Regular track Jump) Spindle waveform during play operation Spindle waveform during play operation (Wider) Ref.: Ref.: Ref.: REFO REFO REFO Mode: Mode: Mode: Normal Normal Normal DEH-30MP/XU/EW...
Page 29
500 mV/div 4 LOEJ 3 12SNS 8 TIN 5 V/div 5 V/div 500 mV/div CD-DA → CD-ROM mode change(Band key) 12 cm CD Eject operation 8 cm CD Eject operation Ref.: Ref.: Ref.: REFO Mode: Mode: Mode: Normal Normal Normal DEH-30MP/XU/EW...
Page 30
7 CIN 8 TIN 500 mV/div 1 V/div 8 TIN ! TE 500 mV/div 1 V/div 9 FIN 1 V/div CD-ROM → CD-DA mode change(Band key) Black dot(800 µm) during play Ref.: Ref.: REFO REFO Mode: Mode: Normal Normal DEH-30MP/XU/EW...
For further information for AUX IN respective destinations, be sure WIRED REMOTO CONTROL to check with the schematic dia- gram. CN621 2.Viewpoint of PCB diagrams Capacitor Connector SIDE A SIDE B P.C.Board Chip Part CN701 CN901 CN1801 DEH-30MP/XU/EW...
Page 33
SIDE A FRONT SUBWOOFER ANTENNA FRONT DEH-30MP/XU/EW...
4.3 CD CORE UNIT(S10.5COMP1) SIDE A CD CORE UNIT(S10.5COMP1) PICKUP UNIT(P10.5)(SERVICE) CN701 REFO1 HOME CN901 LOADING /CARRIAGE MOTOR SPINDLE MOTOR IC203 IC301 DEH-30MP/XU/EW...
Page 39
SIDE B CD CORE UNIT(S10.5COMP1) 12EJ DSCSNS DEH-30MP/XU/EW...
R 180 (B,119,98) RS1/16S0R0J R 301 (B,130,111) RS1/16S471J Q 912 (B,21,74) Transistor UMD2N Q 931 (B,64,92) Transistor UMX1N R 303 (B,129,111) RS1/16S471J Q 951 (B,84,92) Transistor 2SA1037K R 304 (B,145,111) RS1/16S471J D 701 (A,25,57) Diode HZS7L(C3) R 306 (B,147,111) RS1/16S471J DEH-30MP/XU/EW...
Page 41
(B,64,38) RS1/16S822J R 708 (B,57,47) RS1/16S221J R 709 (B,48,47) RS1/16S221J CAPACITORS R 710 (B,57,50) RS1/16S221J C 153 (B,163,71) CKSRYB224K16 R 711 (B,52,42) RS1/16S221J C 154 (B,133,67) CKSRYB474K10 R 712 (B,57,53) RS1/16S221J C 155 (B,160,69) CKSRYB224K16 R 713 (B,61,34) RS1/16S102J DEH-30MP/XU/EW...
Page 42
YAW5064 C 901 (B,57,121) CKSRYB104K50 C 911 (A,32,59) CEJQ470M10 RESISTORS C 912 (B,25,75) CKSRYB103K50 C 913 (A,25,68) 470µF/16V CCH1331 R 1801 (B,28,73) RS1/16S222J C 921 (B,19,108) CKSRYB103K50 R 1802 (B,29,73) RS1/16S222J C 922 (A,20,104) CEJQ221M10 R 1803 (B,20,130) RS1/4SA561J DEH-30MP/XU/EW...
Page 43
C 239 (A,46,74) CCSSCH220J50 R 229 (A,44,72) RS1/16SS472J R 232 (A,46,75) RS1/16SS122J C 246 (A,42,80) CKSSYB104K10 R 241 (B,26,63) RS1/16SS333J C 250 (A,42,81) CKSRYB102K50 R 243 (B,26,62) RS1/16SS333J C 251 (A,41,83) CKSRYB102K50 R 245 (B,26,69) RS1/16SS333J C 303 (A,18,20) CKSSYB472K25 DEH-30MP/XU/EW...
Page 44
C 703 (B,28,42) CKSSYB103K16 C 706 (B,34,43) CKSSYB104K10 C 707 (A,36,57) CKSSYB104K10 C 714 (A,24,41) CKSSYB104K10 C 722 (B,29,45) CKSQYB475K6R3 C 903 (B,14,54) CKSSYB471K50 C 907 (B,14,62) CKSSYB103K16 Miscellaneous Parts List Pickup Unit(P10.5)(Service) CXX1942 Motor Unit(SPINDLE) CXC4166 Motor Unit(LOADING/CARRIAGE) CXC4026 DEH-30MP/XU/EW...
1k ohms in series. • The load and eject operation is not guarantied with the mechanism upside down. If the mechanism is blocked due to mistaken eject operation, reset the product or turn off and on the ACC to restore it. DEH-30MP/XU/EW...
Page 46
• When the power is turned on/off the jump mode is reset to the Single TR (91) while the gain of the RFAMP is reset to 0 dB. At the same time all the self-adjusting values shall return to the default setting. DEH-30MP/XU/EW...
Because of eccentricity in the disc and a slight misalignment of the clamping center the grating waveform may be seen to "wobble" ( the phase difference changes as the disc rotates). The angle specified above indicates the average angle. • Hint Reloading the disc changes the clamp position and may decrease the "wobble". DEH-30MP/XU/EW...
Remarks: Mechanical errors are not displayed (because a CD is turned off in these errors). Unreadable TOC does not constitute an error. An intended operation continues in this case. Upper digits of an error code are subdivided as shown below: 1x: Setup relevant errors, 3x: Search relevant errors, Ax: Other errors. DEH-30MP/XU/EW...
Grille Assy. Fig.1 Grille Assy Removing the Tuner Amp Unit (Fig.2) Remove the screw. Remove the three screws. Straighten the tabs at three locations indicated. Remove the screw and then remove the Tuner Amp Unit. Tuner Amp Unit Fig.2 DEH-30MP/XU/EW...
Page 51
Upper Frame. 3. While lifting the Carriage Mechanism, remove it from the three Dampers. Caution: When assembling, be sure to apply some alcohol to the Dampers and assemble the mechanism in a clamped state. Damper Damper Carriage Mechanism Lower Frame DEH-30MP/XU/EW...
Page 52
Assemble the sub unit side of the Pickup, taking the plate (Chassis) in-between. When treating the leads of the Load Carriage Motor Assy, do not make them loose over the Feed Screw. Poly Washer Change Arm Pickup Lock Arm Inner Holder Feed Screw Planet Gear Pickup Rack Chassis Pickup DEH-30MP/XU/EW...
Power supply Not used TUNPCE2 TUNER : Chip enable output(EEPROM) TUNPCE1 TUNER : Chip enable output(PLL) TPCK TUNER : Clock output(PLL) TPDI TUNER : Data input(PLL) 69-73 Not used RDS : Clock input LDET RDS : PLL lock sense input DEH-30MP/XU/EW...
Page 55
Signal level input VREF Reference voltage AVCC Analog power supply Not used * PEG159A IC's marked by * are MOS type. Be careful in handling them because they are very liable to be damaged by electrostatic induction. BD4843G Vref DEH-30MP/XU/EW...
Page 58
Crystal oscillator connection pin Crystal oscillator connection pin 25,26 KDT2,3 Key data input Not used KST4 Key strobe output 29-32 Not used 33-55 SEG35-13 LCD segment output Power supply 57-64 SEG12-5 LCD segment output * PD6340A NJM2886DL3-33 Thermal Protection Bandgap Reference CONTROL DEH-30MP/XU/EW...
Page 59
Ground for 1.6 V digital circuits D1.GND Output of 33.8688 MHz(CLK for SDRAM) C33M DRAM cs (rcs) Output of DRAM address 11 RA11 Output of DRAM CKE (CKE) Output of DRAM ras Output of DRAM lower cas(LDQM) cas)(LDQM) Output of DRAM upper cas(UDQM) cas!(UDQM) DEH-30MP/XU/EW...
Page 60
Connected to the capacitor for output of REFOUT REFC Reversal input of FE Output of FE Input of FE, TE A/D converter ADIN Reversal input of TE Output of TE Output of LD Input of PD Ground for digital circuits D.GND * UPD63763CGJ DEH-30MP/XU/EW...
Page 61
VD power supply control output VDCONT CD LSI serial data input CD LSI serial data output CD LSI serial clock output xwait CD LSI wait control signal input CD LSI address strobe output XASTB Address/data Bus 0 Not used DEH-30MP/XU/EW...
Page 62
71-75 Address/Data Bus 5 FLMD1 77-90 Not used Not used 91-93 csens Not used Not used TYPE_A/D Not used 96,97 TEMP Not used VD power supply short sense input VDSENS DSCSNS Not used * PE5505A Format meaning C MOS DEH-30MP/XU/EW...
Page 63
22 AUDIOGND audio ground Ground of audio block 23 L ch O L channel output FM stereo “L-ch” signal output or AM audio output 24 R ch O R channel output FM stereo “R-ch” signal output or AM audio output DEH-30MP/XU/EW...
In case of the above signal, the communication with Grille microcomputer may fail. Source keys If the time interval is not 300msec, the oscillator operative may be defective. Source ON SYSPW←H Pin 48 Completes power-on operation. (After that, proceed to each source operation) DEH-30MP/XU/EW...
Page 68
About the fixing screws for the front panel If you do not operate the Detaching and Replacing the Front Panel Function, use the supplied fixing screws and fix the front panel to this unit. Fixing screw (CBA1994) Fixing screw (CBA1994) DEH-30MP/XU/EW...
Page 70
CD Mechanism Module Before shipping out the product, be sure to clean the following portions by using the prescribed cleaning tools: Portions to be cleaned Cleaning tools CD pickup lenses Cleaning liquid : GEM1004 Cleaning paper : GED-008 g p p DEH-30MP/XU/EW...