Device Settings - Motorola CA50 Developer & User Manual

8 - 14 CA50/UCA Client & Server Developer & User Guide
Logging Settings
Table 8-6
Field
Off No logging.
Info Logs high level information such as device and server IP addresses.
Error Logs all error messages along with information messages.
Warn Logs information, error and warning messages.
Debug Logs all messages

Device Settings

This section captures the device settings such as backlight and RF sample time.
Device Settings
Figure 8-17
Device Settings
Table 8-7
Field
AC Backlight On Key Press
AC Backlight Timeout
AC Power Check Interval
Min Signal Strength
RF SampleTime
Good RF SampleThreshold
Bad RF SampleThreshold
Notif Msg Vibrate Cycle Count
Press key to turn on the backlight (device is in the cradle).
Sets the time in seconds that the backlight stays on (device is in the cradle).
Sets the time in seconds that the device uses to check if it is in the cradle.
Sets the minimum RF signal strength to be connected (the numbers are negative; the
larger the negative number, the weaker the signal, e.g., -70 is weaker than -60).
Sets the time in seconds for the RF signal strength sampling.
Sets the number of times the RF sample signal strength must be above the minimum
signal strength before the bad sample count is reset.
Sets the number of times the RF sample signal strength must be below the minimum
signal strength before the Network Connection Lost message displays.
The number of times the device should vibrate on receipt of notification message.
Description
Description