Yamaha CDC-585 Service Manual page 6

CDC-585/CDC-506/CDC-685/CDC-906
QQ
3 7 63 1515 0
DISASSEMBLY PROCEDURES
1. Removal of Top Cover
a. Remove 4 screws ( q ) and also 3 screws ( w ) as
shown in Fig. 1.
2. Removal of Clamp Ass'y
a. Remove 2 screws ( e ) as shown in Fig. 1.
3. Removal of Tray Ass'y
a. Remove 1 screw ( r ) as shown in Fig. 1.
b. Turn Gear/L0 as shown in Fig. 2 counter clockwise
gradually until immediately before the tray starts to
move and stop it there.
CAUTION : Gear/L0, if turned counter clockwise con-
tinuously, will mesh with the gear of the
tray and the tray will come out. When re-
moving the tray, use care so that Gear/L0
will not mesh with the gear of the tray.
c. Pull out the Tray Ass'y.
Top Cover
q
TE
L 13942296513
Plate/Table
y
r
Table
Tray
Front Panel
www
.
7
http://www.xiaoyu163.com
(Remove parts in the order as numbered.)
w
e
q
Clamp Ass'y
t
Support/T
Fig. 1
Tray
x ao u163
y
Gear/L0
i
Fig. 2
http://www.xiaoyu163.com
2 9
8
4. Removal of Table
a. Remove 1 screw ( t ) and then remove the Support/
T as shown in Fig. 1.
b. Remove the Plate/Table as shown in Fig. 1.
c. Remove 1 screw ( y ) and then take off the Table as
shown in Fig. 1.
Precaution for installation of the Tray Ass'y.
On Tray Ass'y setting.
Check the Direction of marking " " on gear
according to this drawing.
Gear/L01
Marking
Q Q
3 6 7 1 3 1 5
IMPORTANCE : Installation of Table.
Install the table according to the following procedure.
1) Slide the Lever so that the Gear/RT1 be-
comes free. (Fig.B-1)
2) With the " " mark on the Gear/RT1 aligned
with the same mark on the Tray, lock it with
the Lever. (Fig.B-1)
3) Install the Table by aligning it to the thick line
/
on " " mark. (Fig.B-2)
*Check that the Table is locked after installation.
Gear/RT1
Tray
Lever
Lock
Unlock
Fit the table to the thick line on "
co
.
9 4 2 8
Gear/L0
Front Panel
Fig. A
0 5 8 2 9 9 4 2 8
Fit the Gear/RT1 to " " mark.
Fig. B-1
/
m
" mark.
Tray
Table
Fig. B-2
9 9
9 9