Setting The Addresses Of The Two Cameras Of The Mic612 - Bosch MIC612 Operation Manual

MIC612 Thermal Camera
Notice!
FastAddress applies to the optical camera only; it does not apply to the thermal camera.
Notice!
You do not need to set a camera address if using Bilinx communication.
FastAddress is stored in nonvolatile memory and does not change if the power is turned off
or if the default settings are restored.
7.5

Setting the Addresses of the Two Cameras of the MIC612

After the MIC612 camera is on, you must set the camera address. The optical camera and the
thermal camera of the MIC612 have different addresses. The address of the optical camera is
set via the OSD and FastAddress. The address of the thermal camera is set via the OSD and a
unique address. From the factory, the default address of the optical camera is "0" and the
default address of the thermal camera is the address of the optical camera + 1.
The figure below illustrates the connection configuration of a MIC612, a matrix switcher, a
monitor, and a keyboard.
Bosch Security Systems Operation Manual
Getting Started | en 35
2016.03 | 2.1 | F.01U.249.416