Dsl: Circuit Configuration - Motorola 2200 Administrator's Handbook

Link: DSL: Circuit Configuration
The DSL Circuit Configuration screen shows the traffic sent and received over the DSL line as well as the
trained rate (upstream and downstream) and the VPI/VCI. Verify traffic is being sent over the DSL line. If
not, check the cabling and make sure the Gateway is not connected to a micro filter. Also verify the correct
PVC is listed, which should be 0/35 (some providers use other values, such as 8/35. Check with your pro-
vider). If not go to the WAN setup and change the VPI/VCI to its correct value. Below is an example:
ATM port status
Rx data rate (bps) : 8000
Tx data rate (bps) : 800
ATM Virtual Circuits:
VCC #
---- ----
1
ATM Circuit Statistics:
Rx Frames
Rx Octets
Rx Errors
Rx Discards
No Rx Buffers :
: Up
Type VPI VCI Encapsulation
--- ----- --------------------------
PVC 8 35 PPP over Ethernet (LLC/SNAP encapsulation)
: 17092
: 905876
: 0
: 0
0
Tx Frames : 25078
Tx Octets : 1329134
Tx Errors :
Tx Discards :
Tx Queue Full :
0
0
0
215