Adjustment - Toshiba e-STUDIO165 Service Manual

3.

ADJUSTMENT

3.1 Adjustment of Auto-Toner Sensor
When the developer material is replaced, adjust the auto-toner sensor in the following procedure.
<Procedure> (Adjustment Mode (05-200))
(1) Install the process unit into the equipment.
Note: Note:
Do not install the toner cartridge.
(2) While pressing [0] and [5] simultaneously, turn the power ON.
The following message will be displayed.
(3) Key in code [200] and press the [ENTER] button.
The display changes as follows and the "density LEDs" lights from the left in order.
[2][0][0]
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[0][5]
[POWER]
Fig. 3-1
[ENTER]
Fig. 3-2
3 - 1
06/04
e-STUDIO165/167/205/207/237
ADJUSTMENT
3