Installer Setting - Setting Address Of Central Control - LG PREMTB10U Installation & Operation Manual

INSTALLATION INSTRUCTIONS
68

Installer Setting - Setting Address of Central Control

After installing the product, you must run a Test Run mode.
For details related to this operation, refer to the product manual.
1 Press the button for 3 seconds to enter
the Thermostat installer setter setup
mode.
- If pressed for a shorter time, it enters
into user setup mode.
If entering into address setup mode by using
2
button, it indicates as picture below.
Set Group No. by pressing
3
buttons.(0~F)
Move to Indoor No. setting option
4
by pressing
Set Indoor No. by pressing
5
buttons.
6 Press button to save.
Pressing button will exit settings mode.
7
After setup, it automatically exits after 25
seconds if there is no input. If the
Setting/Cancel button is not pressed, the
mode will not change.
Indoor No.
Group No
Function Code
buttons.