Sharp 64LHP5000 Service Manual page 12

64LHP5000
PROJECTOR UNIT
1
2
3
4
5
6
VCR CONTROL BUTTONS
If the VCR is preset by OPERATION OF REMOTE CONTROL, the
remote control unit button will function as follows when the mode
switch of the remote control unit is set to VCR.
When the input button having the same number as the input
terminal connecting the VCR is pressed, the VCR can be operated
using buttons 1 to 9.
VCR which are made by other makers and are not preset can also
be operated using the remote control unit if buttons 1 to 9 have
learnt the functions.
1 Numeric buttons
Use to enter two-digit code numbers when identifying your VCR.
2 \\ REW
Press to rewind a tape. For some VCRs you may need to press
STOP first, then REWIND.
In Playback mode, hold button down to view picture moving
rapidly in reverse.
3 | PLAY
Press to play back a tape.
4 â PAUSE
Press to temporarily stop the tape during playback or recording.
Press again to release Pause.
5 Ë STOP
Press to stop the tape.
6 Æ REC
Press to begin recording.
7
7 FF ||
Press to rapidly advance the tape. For some VCRs, you may
8
need to press STOP first, then FF.
In Playback mode, hold button down to view the picture moving
rapidly in forward direction.
9
8 VCR CHANNEL UP (')/ DOWN (")
Press to scan up or down through the channels on the VCR.
9 VCR POWER Æ
Press to turn the VCR on and off.
12