Internet Setup; Pppoe (Dsl) - D-Link DIR-822 User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your
computer. The software is no longer needed and will not work through a router.
My Internet Connection: Select PPPoE (Username/Password) from the
drop-down menu.
Address Mode: Here the user can specify whether this Internet
connection requires the use of a Dynamic or Static IP
address. PPPoE usually requires a Dynamic IP
configuration.
IP Address: Enter the PPPoE IP address used here. This option is only
available if Static IP is selected.
Username:
Enter the PPPoE account username used here. This
information is given by the ISP.
Password: Enter the PPPoE account password used here. This
information is given by the ISP.
Verify Password: Re-enter the PPPoE account password used here.
Service Name: This optional field enables the user to enter a service
name to identify this Internet connection here.
Reconnect Mode:
Use the radio buttons to specify the reconnect mode.
The user can specify a custom schedule or specify the
On Demand, or Manual option. To specify a custom
schedule, use the drop-down menu to select one of the
schedules that has been defined in the Schedules page.
To create a new schedule, click the New Schedule button to open the
Schedules page. Schedules will be discussed later.
D-Link DIR-822 User Manual

Internet Setup

PPPoE (DSL)

31