Spin Basket Vanes; Removing The Spin Basket Vanes - Electrolux 6000 series Service Manual

15. The seal between the (2) tub halves is placed in the
groove of the rear half and can be lifted out.
16. To remove the spin basket, set the back half of the
outer tub on it's side, reinstall the screw that holds
the large pulley on and tap the inner tub out with a
rubber hammer.
Note: The bearings, water seal and seal between
the two tubs come as part of the rear half of
the outer tub. If the water seal or bearings
fail, inspect and if necessary dress the shaft
of the spin basket with a file. With some
failures, it may be necessary to replace the
spin basket.

Spin basket vanes:

There are three plastic vanes mounted to the spin basket
to aid in the washing action during the wash cycle. The
vanes are held to the spin basket by (6) tabs that are
slipped into slots in the spin basket and locked in
place by (4) tabs pressed out of the spin basket.

Removing the spin basket vanes:

1. Open the washer's loading door.
97