Basic Administration and Configuration
Upgrading, Rebooting, and Resyncing Your ATA Device
Upgrading, Rebooting, and Resyncing Your ATA Device
NOTE
Cisco Small Business ATA Administration Guide
Advanced Configurations
Other parameters may need to be changed from the defaults, depending on the
requirements of a specific ITSP. Some of the commonly configured parameters
include the following:
Streaming Audio ServerYou can enable an external music source for music
on hold. See the
Configuring the Streaming Audio Server, on page 85
further information.
NAT SettingsYou can adjust these settings to resolve issues that arise when
using a ATA on a network behind a Network Address Translation (NAT) device.
See the
Network Address Translation (NAT) and Voice over IP (VoIP), on
page 42
for further information.
Subscriber InformationYou can configure security parameters. See the
Secure Call Implementation, on page 66
Dial PlanYou can configure a dial plan for a specific line. See the
Configuring Dial Plans, on page 56
The administration web server supports upgrading, rebooting, and resyncing
functions through special URLs. Administrator account privilege is needed for
these functions.
Upgrade URL
The Upgrade URL lets you upgrade the ATA device to the firmware specified by
the URL, which can identify either a TFTP or HTTP server.
If the value of the
cannot upgrade the ATA device even if the web page indicates otherwise.
The syntax of the Upgrade URL is as follows:
Both HTTP and TFTP are supported for the upgrade operation.
for further information.
for further information.
parameter in the Provisioning page is No, you
2
for
38