Quick Start Guide
Evaluation Board (EVB) PAN1311/21 USB
2. INTRODUCTION
This document should provide the minimum knowledge needed to establish a simple
connection between two PAN1321ETU USB Evaluation Boards (EVB) using Infineon
eBMU_SPP_Toolbox software. For this limited information is granted. To learn about all
aspects of the software please refer to the related documents listed below.
2.1 RELATED DOCUMENTS
For further information on Infineon eBMU_SPP_Toolbox software and it's implemented AT
command set please refer to:
PAN13x1_ReleaseNote_SPP_AT_SW08_V1.8_RN_Rev1.0_DRAFT
•
PAN13x1_ReleaseNote_SPP_AT_SW21_V2.1_RN_Rev1.0_DRAFT -iPhone version
•
PAN13x1_SPP_AT_UserManual_SoftwareDescription_Rev5.0 DRAFT
•
PAN1321_AN_DesignGuide_Rev2 1
•
User's_Manual_PAN1311_V20.xx_Rev1.1
•
User's_Manual_PAN1321_V20.xx_Rev3.1
•
4. FUNCTIONAL OVERVIEW
The figure below shows an overview of the Evaluation Board. If there is the need to connect
your µController to the EVB please de-solder R1, R2, R3, R4.
For more details please refer also to the schematic in chapter Schematic.
Hardware
Reset
For interfaces
description refer to
schematic
PANASONIC ELECTRONIC DEVICES EUROPE
Figure 2 : Evaluation Board Overview
GmbH
No.
DS-PAN1311/21USB
PAGE
DATE
Power Supply
section
UART to USB
Converter Section
REV.
1.1
3 of 11
15.09.2011
DESIGNED
Erstellt
IW