Epson DM-D500 Technical Reference Manual page 35

7
Connect the DC cable connector of the power supply unit, with the arrow on the con-
nector face up, to the connector for power supply unit connection (indicated as
POWER IN) inside the DP-501.
• For power supply unit, use the optional PS-180.
• When connecting or disconnecting the DC cable of the power supply unit, be sure the power plug of
the power supply unit is disconnected from the power outlet.
• When disconnecting the DC cable of the power supply unit, disconnect by holding the connector.
Pulling on the cable may damage the cable.
Connector for power supply unit connection
8
Set the jumpers.
(See "Setting the jumpers" on page
9
Lay the connection cables neatly so that they do not cross one another. Also, shape
the DM-D500 modular cable so that it fits inside the DP-501.
10
Place the base plate in the DP-501 by following the order indicated by the arrows.
Be sure to push the base plate all the way in until it is locked by the hooks on the DP-501.
11
When using the extension support, attach hook and loop fastener to the four corners
of the base plate to prevent the unit from falling down, and install in the designated
place.
12
Plug in the power supply unit to a power outlet.
31)
Chapter 2 Setup
DC cable
35
2