Table of Contents
Advertisement
When deleting or changing the pre-assigned card type, the conditions should be the
followings:
The card status is OUS or Fault.
l
All of the port data has been deleted.
l
However, if there exist port data, it is possible to change the cards as follows:
PLC card MHLC card
l
SLC card MHLC card
l
Deleting the ATLC card will be an error if there exist the following assignments:
'Trunk Group (TGl)".
l
Incoming Mode (Day) is set to '7 (ATT)."
Intercept Routing (Day) is set to "A (ATT)."
"Doorphone (DPH)",
l
Doorphone Assignment is set to
Deleting the DISA card will be an error if there exist the following assignments:
"Trunk Group (TGl)",
l
Incoming Mode (Day) is set to "4 (DISA)."
Incoming Mode (Night) is set to "4 (DISA)."
Deleting the HLC, SLC, LCOT or GCOT
to be deleted:
"Power Failure Transfer (Pmjn
l
See Section 1 -A-5.00 "Service Cards Description" for installing the cards in combination.
will be an error if there is the following assignment to the slot
card
lo-c-4
(70695)
Advertisement
Chapters
Table of Contents
