NEC DTL-8R-1G Quick Reference Manual

DTL-8R-1G Quick Reference Guide
Thank you for choosing the Dterm Cordless DECT terminal
.
DTL-8R-1G Cordless
1. DTL-8R-1G Cordless
2. Message Display
3. Hold (HOLD) Key
4. Conference (CONF) Key
5. Talk (TALK) Key
6. Mute/Menu (MUTE) Key
7. Numeric Keypad
8. Upper: Programmable Keys (F1-F4)
Lower: Programmable Keys (F5-F8)
9 Headset Jack
10. Microphone
LIABILITY DISCLAIMER
NEC Corporation reserves the right to change the specifications, functions, or features, at any time, without notice.
NEC Corporation has prepared this document for use by its employees and customers. The information contained herein is the property of NEC
Corporation and shall not be reproduced without prior written approval from NEC Corporation.
Copyright 2012 NEC Corporation
NEC Corporation
DTL-8R-1G Base Unit
11. Redial (REDIAL) Key or
12. Transfer (TRANS) Key
13. Hands Free (SPK Icon) Key
14. Programmable Key Labels
15. Volume UP/Ringer Volume Key
16. Volume Down/Ringer Mute Key
17. Switch to Cordless
18. Power LED
19. Switch to Desk Phone
20. Stand
Make Calls
Making Internal Calls
Lift the cordless if it is in the charger;
1. Press the TALK Key on the Cordless,
"ACQUIRING LINK" blinks on the LCD to connect to
the Base Unit
2. When connected to the Base Unit, the TALK icon
is displayed and the current volume setting is shown
.
for two seconds.
3. Dial the extension number of the required party.
If you dial "1" "0" "2", the LCD shows the dialed
number as they are pressed.
Making Outside Calls
Lift the cordless if it is in the charger;
1. Press the line key to access the specific outside
line.
Or
Press the TALK Key and dial the line access code.
2. Dial the telephone number of the required party.
Redialing a Previous Number
.
Lift the cordless if it is in the charger;
1. Press the TALK Key on the Cordless.
The last dialed call is displayed and dialed.
.
Receive Calls
1. When an incoming call is received, the caller ID is
shown on the LCD.
2. Press TALK Key, any other dial key (0-9, *, #) or
.
lift Cordless from charger, "ACQUIRING LINK" blinks
on the LCD to connect to the base unit
3. When connected to the base unit, the TALK icon is
displayed and the current volume is shown for two
.
seconds.
The call is connected.
ACQUIRING LINK
Volume
Low High
9012345678
CALL FROM EXT 200
ACQUIRING LINK
Volume
Low High
Issue-1.0 January 2012
102
204