Handlebar Adjustment; Wheel Nut Torque Specifications - Craftsman 108.27807 Operator's Manual

Handlebar Adjustment

WARNING
Improper adjustment of the handlebars or incorrect torque of the adjuster block
tightening bolts can cause limited steering or loosening of the handlebars,
resulting in loss of control and possible serious personal injury or death.
Your ATV has handlebars which can be adjusted for your personal fit.
1. Remove the handlebar cover.
2. Loosen the four bolts.
3. Adjust handlebar to desired
height. Be sure handlebars
do not hit gas tank or any
other part of machine when
turned fully to the left or right.
4. Torque handlebar adjuster
bolts to 10-12 ft.Ibs (14-16
Nm).
NOTE: Tighten bolts so there is an equal gap at the front and rear of the handlebar
block. Improper gap will result in improper fit of upper part.
Miscellaneous Adjustments
The following items should be checked occasionally for tightness, or if they have
been loosened during maintenance service.

Wheel Nut Torque Specifications

Bolt Size Specification
Front
20 Ft.Lbs
M10 X 1.25
Rear
50 Ft.Lbs
M12 X 1.25
NOTE: An authorized service center must service all nuts that have a cotter pin
installed. Call 1-800-643-7332 for service.
27N.m
69N.m
61