Configuring Your Camcorder To Enable Wi-Fi Connections - Sony CBK-WA01 Operating Instructions Manual

Configuring Your
Camcorder to Enable
Wi-Fi Connections
Notes
• Check the firmware version of your camcorder to make
sure that the camcorder supports the Wi-Fi adapter.
For details, contact your Sony dealer or a Sony service
representative.
• In order to use the Wi-Fi connection feature, you must
have an installation key. If an installation key has not
been entered, then the Wi-Fi items will not appear in the
setup menu.
• The procedure below illustrates the use of the PDW-700.
For procedures for using other camcorders to make Wi-
Fi connections, refer to the OPEARTION MANUAL or
Operating Instructions supplied with each camcorder.
For details about the menu operations of the PDW-700,
refer to the OPEARTION MANUAL supplied with the
PDW-700.
If the PDW-700 is connected to the computer via a LAN
cable, you can use the Web menu to perform steps 2
onward (see page 12).
1
Make the following settings on the 007 POWER
SAVE page of the OPERATION menu.
ETHERNET/USB : ENABL
Wi-Fi
2
Select NETWORK SETUP: EXEC on the M23
NETWORK 1 page of the MAINTENANCE menu,
and press the MENU knob.
6

Configuring Your Camcorder to Enable Wi-Fi Connections

: ENABL
The NETWORK SETTING page appears.
3
On the NETWORK SETTING page, set DHCP to
"DISABLE" and change the value of IP ADDRESS as
required.
The default IP address is "192.168.1.10".
4
Select "SET", and press the MENU knob to return to
the M23 NETWORK 1 page.
5
Clear the menu display.