To Remove accessory: Repeat steps
and 2J Press access0ry upward as far_
possible and turn tO the left. Then pull
accessory from the beater shaft.
Your Stand Mixer is adjusted at the factory so the fiat beater just clears the bottom
of the
bowl. if, for any reason, the flat beater hits the bottom of the bowl or is too far away from
the bowl, you can correct clearance easily.
Stand Mixer.
NOTE:
When properly
adjusted, the flat
beater wilt not strike on the bottom
or
side of the bowl. if the flat beater or the
wire whip is so close that it strikes the
bottom
of the bowl, coating may wear off
the beater or wires on whip may wear.
lever
may not loci< into place.