Download Print this page

Craftsman 138.88784 Operator's Manual page 13

Advertisement

Available languages

Available languages

IF THESE SOLUTIONS
DO NOT SOLVE THE PROBLEM
CONTACT A QUALIFIED SERVICE
DEALER.
PROBLEM
The handle is not
in position.
The snow thrower
does not start.
POSSIBLE
CAUSE
The bolts are not properly
seated.
Handle knobs not tightened.
The battery is not charged.
The switch is defective.
The battery is not attached to
the motor.
Battery may require service or
replacement.
The motor is on, but The belt is damaged.
the impeller does
not turn.
The snow thrower
The scraper is worn.
Replace the scraper (see the section
leaves a thin layer of
entitled Replacing the Scraper).
snow behind.
SOLUTION
Adjust the height of the handle, and verify
that the carriage bolts are properly seated.
Tighten the knobs.
Charge the battery.
Replace the switch. (Call the tollfree
helpline, at 1-888-266-7096)
Check the connection between the motor
connector and the battery.
Call toll free helpline, at 1-888-266-7096
or replace battery.
Replace the belt (see the section entitled
Inspecting/Replacing
the Drive Belt).
13 -- English

Advertisement

loading