Makita 3707FC Instruction Manual page 9

2
1
1. Screws
2. Base protector
3. Screwdriver
3
4
1
2
5
7
1. Base
2. Templet
3. Straight bit
4. Templet guide 10
5. Distance (X)
6. Workpiece
7. 10 mm (3/8")
Loosen the screws and remove the base protector. Place the
001704
templet guide on the base and replace the base protector.
3
Then secure the base protector by tightening the screws.
1
Secure the templet to the workpiece. Place the tool on the
001705
templet and move the tool with the templet guide sliding
along the side of the templet.
NOTE:
The workpiece will be cut a slightly different size from the
6
templet. Allow for the distance (X) between the router bit and
the outside of the templet guide. The distance (X) can be
calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - router
bit diameter) / 2
Straight guide (optional accessory)
001706
The straight guide is effectively used for straight cuts when
chamfering or grooving.
9