Making Precise Measurements - Epson Runsense SF-110 User Manual

The product continues to search for a GPS signal, and
starts recording positional information when it
successfully synchronizes with a satellite. The route
you have travelled before the GPS has synchronized is
not recorded, but distance and pace data can still be
measured. The product will use the stride sensor until a
GPS connection is made.
See "Measurable items" on page 31.
Indoor mode
This function allows you to measure without
performing GPS positioning.
Your route is not recorded in Indoor mode. The
measurements recorded by your product are also
limited in Indoor mode.
See "Measurable items" on page 31.
Use either of the following methods to enter indoor
mode.
O Press C or D to highlight Indoor during GPS
positioning, then press A.
O If GPS positioning fails, press C or D to highlight
Indoor on the screen displayed, then press A.

Making precise measurements

When you use the product for the first time or when
the product has not been used for several months, you
need to allow the product to completely synchronize
with the GPS satellites. Switch to the Measurement
screen, then wait outside for at least 15 minutes with no
obstructions overhead. Your product will track your
movements with greater accuracy after this extended
calibration.
Setting up your SF-110
You will not need to repeat this process again unless
you do not use the product for several months.
23