EN GLI SH HEAVY-DUTY ROTARY HAMMERDRILL D25112(C), D25113, D25114, D25213 Congratulations! You have chosen a D WALT tool. Years of experience, thorough product development and innovation make WALT one of the most reliable partners for professional power tool users. Technical Data D25112(C) D25113 D25114...
EN GL IS H Vibration emission value a Screwdriving without impact m/s² < 2.5 Uncertainty K = m/s² The vibration emission level given in this information NOTICE: Indicates a practice not sheet has been measured in accordance with a related to personal injury which, if standardised test given in EN 60745 and may be not avoided, may result in property used to compare one tool with another.
EN GLI SH SAVE ALL WARNINGS AND INSTRUCTIONS Use personal protective equipment. FOR FUTURE REFERENCE Always wear eye protection. Protective equipment such as dust mask, non-skid The term “power tool” in the warnings refers safety shoes, hard hat, or hearing protection to your mains-operated (corded) power tool or used for appropriate conditions will reduce battery-operated (cordless) power tool.
EN GL IS H Maintain power tools. Check for be hazardous as well. Tighten the side handle misalignment or binding of moving parts, securely before use. breakage of parts and any other condition • Do not operate this tool for long periods of that may affect the power tool’s operation.
EN GLI SH INTENDED USE Wear ear protection. These heavy-duty rotary hammers have been designed for professional drilling and hammerdrilling, screwdriving and light chipping Wear eye protection. DO NOT use under wet conditions or in presence of flammable liquids or gases. These hammerdrills are professional power tools.
EN GL IS H Using an Extension Cable WARNING: Do not select the operating mode when the tool is running. An extension cord should not be used unless absolutely necessary. Use an approved extension Indexing the Chisel Position cable suitable for the power input of your charger (fig.
EN GLI SH Setting the Drilling Depth (fig. 5) WARNING: Never use standard chucks in the hammerdrilling mode. 1. Insert the required drill bit as described above. Replacing the Dust Cover (fig. 3) 2. Press the depth stop clamp (k) and keep it depressed.
Page 13
EN GL IS H 3. To stop the tool, release the switch. 8. Always switch off the tool when work is finished and before unplugging. 4. To stop the tool in continuous operation, press the switch briefly and release it. Always switch Rotary Drilling (fig.
EN GLI SH 5. Always switch off the tool when work is finished air vents. Wear approved eye protection and before unplugging. and approved dust mask when performing this procedure. WARNING: • Do not use this tool to mix or pump WARNING: Never use solvents or easily combustible or explosive fluids other harsh chemicals for cleaning the...
Page 15
EN GL IS H You can check the location of your nearest GUARANTEE authorised repair agent by contacting your local WALT office at the address indicated in this manual. Alternatively, a list of authorised D WALT WALT is confident of the quality of its repair agents and full details of our after-sales products and offers an outstanding guarantee service and contacts are available on the Internet at:...
Page 16
Black & Decker - D WALT Tel: +32 (0)015 - 15 47 9211 België en Luxemburg Nieuwlandlaan 7, IZ Aarschot B156 Fax: +32 (0)015 - 15 47 9210 B-3200 Aarschot www.dewalt.be Danmark WALT Tlf: 70201511 Sluseholmen 2-4 Fax: 70224910 2450 København SV www.dewalt.dk...