Table of Contents
Advertisement
1 Product Introduction
Rear Panel
Power: Connect the supplied AC power cable to this port.
DGS-1210-52MP
48-Port 10/100/1000Mbps plus 4 SFP Slot Web Smart PoE Switch.
Front Panel
Power LED : The Power LED lights up when the Switch is connected to a power source.
Mode: To select the mode of port LED, the Link/Act and PoE LED under the mode button will solid green to
indicate which mode is selected.
Pwr Max: The Pwr Max LED lights up with solid red when the Switch reaches the maximum power budget
defined by the administrator via PoE System Settings page of Web GUI or the default power budget of 370
Watts.
Port Link/Act/Speed LED (1-48): The Link/Act/Speed LED flashes, which indicates a network link through
the corresponding port. Blinking indicates that the Switch is either sending or receiving data to the port.
When a port has an amber light, this indicates that the port is running on 10M or 100M. When it has a green
light it is running on 1000M.
Port Link/Act/Speed LED (49F, 50F, 51F, 52F): The Link/Act/Speed LED flashes, which indicates a
network link through the corresponding port. Blinking indicates that the Switch is either sending or receiving
data to the port. When a port has a green light, this indicates that the port is running on 1000M.
Fan Error: The FAN LED shows the status of the fans, light off indicates all fans work fine and the red light
indicates that one or multiple fans are working abnormally.
Reset: Press the Reset button for 5 seconds to reset the Switch back to the default settings. All previous
changes will be lost.
Mode: By pressing the Mode button, the Port LED will switch between Link/Act and PoE modes.
CAUTION: The port 1 ~ port 24 are PoE ports. When user press
the Mode button to PoE mode, only port 1 ~ port 24 will light up.
CAUTION: This equipment can be connected only to PoE
networks without routing to the outside plant.
Figure 1.14 – DGS-1210-52P Rear Panel
Figure 1.15 – DGS-1210-52MP Front Panel
CAUTION: The MiniGBIC ports should use UL listed Optical
Transceiver product, Rated Laser Class I. 3.3Vdc.
CAUTION: The port 1 ~ port 48 are PoE ports. When user press
the Mode button to PoE mode, only port 1 ~ port 48 will light up.
CAUTION: This equipment can be connected only to PoE
networks without routing to the outside plant.
D-Link Web Smart Switch User Manual
8
Advertisement
Table of Contents
