Kenwood TTM550 series Instructions

Please also read the additional Important Safeguards in the
accompanying leaflet
G Do not move the toaster whilst it is
in operation.
Never use an unauthorised
G
attachment or accessory.
We do not recommend using the
G
Use the carriage lever to lift the toaster for non bread items. For
toast to Peek & View™ at any non bread items that are specifically
time without cancelling the toasting recommended for use in a toaster
cycle. follow the manufacturer's guidelines
and cooking instructions. Remove
loose crumbs and clean the crumb
tray before and after use.
1 slot setting, only heats what you
G Never use a damaged toaster. Get it
need, saving 50% energy.
checked or repaired: see 'Service &
before using your Kenwood Customer Care'.
appliance Only use the appliance for its
G
Read these instructions carefully intended domestic use. Kenwood
G
and retain for future reference. will not accept any liability if the
G Remove all packaging and any appliance is subject to improper
labels. use, or failure to comply with these
instructions.
safety
before plugging in
Burnt food can catch fire, so: Make sure your electricity supply is
G G
the same as the one shown on the
never leave your toaster on
G G
unattended; underside of your toaster.
keep your toaster away from
G G
This appliance conforms to EC
G
anything (eg curtains) that could
directive 2004/108/EC on
catch fire;
Electromagnetic Compatibility and
set the browning control lower for
G G
EC regulation no. 1935/2004 of
thin or dry bread;
27/10/2004 on materials intended
never warm food with a topping or
G G
for contact with food.
filling (eg pizza): if it drips into the
Important – UK only
toaster, it could catch fire.
The wires in the cord are coloured
G
Clean the crumb tray regularly:
G G
as follows:
crumbs can smoke or burn.
Green and Yellow = Earth,
G To avoid electric shocks, never:
Blue = Neutral,
let the toaster, cord or plug get wet;
G G
Brown = Live.
or
The appliance must be protected
G
put your hand or anything metal,
G G
by a 13A approved (BS1362) fuse.
eg a knife or foil, into the toaster.
G WARNING: THIS APPLIANCE
G Always unplug the toaster when not
MUST BE EARTHED.
in use, before cleaning or
attempting to clear jammed bread.
Note:
G Never cover your toaster with a
For non-rewireable plugs the fuse
G
plate or anything else - it could
cover MUST be refitted when
overheat and catch fire.
replacing the fuse. If the fuse cover
G Never let the cord hang down
is lost then the plug must not be
where a child could grab it.
used until a replacement can be
G We recommend that you do not
obtained. The correct fuse cover is
use your toaster directly under wall
identified by colour and a
cupboards.
replacement may be obtained from
G External metal surfaces are liable to
your Kenwood Authorised Repairer
get hot especially the top area.
(see Service).
If a non-rewireable plug is cut off it To stop toasting during the cycle,
G G
must be DESTROYED press the 'cancel' button, the toast
IMMEDIATELY. An electric shock will pop up and the 'cancel' button
hazard may arise if an unwanted light will go off.
non-rewireable plug is inadvertently 6 Your toast will pop up
inserted into a 13A socket outlet. automatically, to raise it higher, lift
the lever.
before using for the first
time
hints on using your
G Clip excess cord into the cord
toaster
storage clips in the base .
Operate the toaster once on a
G
G Select a lower setting for light
medium setting without bread.
browning or for dry bread.
(The lever will not stay down unless
G Dry/stale bread toasts more quickly
the toaster is plugged in).
than fresh bread and thinly sliced
G As with all new heating elements,
bread toasts more quickly than
your toaster may emit a slight
thickly sliced bread. Therefore the
burning smell when it is first
browning control should be set at
switched on. This is normal and
a lower setting than usual.
not a cause for concern.
G For best results ensure that the
key bread slices are of an even
thickness, freshness and size.
Peek & View™ carriage lever
G In order to achieve uniform
(with 'Hi-Rise™' for extra lift)
browning we recommend you wait
cancel button with indicator light
a minimum of 30 seconds between
browning control
each toasting so that the control
button with indicator
can automatically reset.
light
Alternatively select a lower setting
crumb tray
when additional toasting is carried
out.
cord storage

care and cleaning

to use your toaster
1 Before cleaning, unplug your
1 Plug the toaster into the power
toaster and let it cool down.
supply.
2 Slide out the crumb tray
2 Move the browning control to the
then replace. Do this regularly:
desired setting. Use a low setting
crumbs can smoke or even burn.
for light toasting and for thin or dry
3 Wipe the outside of the toaster
bread.
with a damp cloth, then dry. Do
3 Insert the bread, muffins, bagels
not use abrasives.
etc.
4 Lower the lever until it locks.
(The lever will not stay down unless
the toaster is plugged in). The
'cancel' button will illuminate.
5 To toast a single slice of bread,
place the bread into the ,
lower the carriage lever and press
the button. The
button will illuminate.
Use the carriage lever to lift the
G
toast to Peek & View™ at any
time without cancelling the toasting
cycle.
. Clean,