Jacking Instructions - Toro Groundsmaster
4000?D Service Manual

PRELIMINARY – For Toro Distributor and Toro Company use only.

Jacking Instructions

When changing attachments, tires or perform-
ing other service, use correct jacks and sup-
ports. Make sure machine is parked on a solid,
level surface such as a concrete floor. Prior to
raising machine, remove any attachments that
may interfere with the safe and proper raising of
the machine. Always chock or block wheels. Use
jack stands to support the raised machine. If the
machine is not properly supported by jack
stands, the machine may move or fall, which
may result in personal injury.
Jacking the Front End (Fig. 1)
1. Set parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack securely under the frame, just to the in-
side of the front tire.
3. Position jack stands or hardwood blocks under the
frame as close to the wheels as possible to support the
machine.
Jacking the Rear End (Fig. 2)
1. Place jack securely under the center of rear axle.
2. Chock both front tires. Jack rear of machine off the
ground.
3. Use jack stands or blocks under the axle to support
the machine.
Safety
CAUTION
2
1. Frame jacking point
2
1. Rear axle jacking point
Page 1 − 4
1
1
Figure 1
2. Front tire
2
1
Figure 2
2. Rear tire
Groundsmaster 4000−D
2