Caller Id Callback (Apt/Dpt Integration Only); Calling A Beeper - Panasonic KX-TVM50 Feature Manual

2.3 Subscribers Features
2.3.7

Caller ID Callback (APT/DPT Integration Only)

Description
Enables a subscriber to call back a message sender with the Caller ID number attached to the
message.
Installation Manual References
"Transfer to Outside Parameters" in 5.2.3 PBX Interface Parameters
Programming Manual References
"Caller ID Callback" in 2.2.2 Personal Options
"Caller ID Callback" in 2.5.4 Parameters
Feature Manual References
2.2.7 Call Transfer to Outside
2.3.8 Calling a Beeper (Pager)
Description
Allows a subscriber to be notified by a beeper (pager) when he or she has messages. If the beeper
(pager) has a display, it is possible to send it a callback number. The callback number can be recorded
when a caller leaves a message. If the caller does not leave a callback number, the System Callback
No., or the caller's number if it is received through a telephone company's Caller ID service, will be
sent instead.
Conditions
• To utilise this feature, follow the procedure below.
1.
Open KX-TVM Maintenance Console. Click Mailbox Setting, select a mailbox to edit, and
click Edit Mailbox.... In Notification Parameter, make one selection from the available
options in "Beeper Callback No. Entry Mode".
2.
In Notification Parameters, edit "Notification Schedule": click Click to edit..., then enter the
beeper (pager) number under "Dial Number" (make sure to enter the connected PBX's Trunk
Access number before the beeper number for dialling outward, then, enter an X after the
beeper number. — the X is for the caller to enter his or her number as the callback number
which will appear on your beeper later.). Finally, select "Beeper" in "Type of Device".
Programming Manual References
2.1.4 Notification Parameters
"System Callback No." in 2.5.4 Parameters
44 Feature Manual